Difference between revisions of "CTWUG Waterproofing"
From CTWUG Wiki
| Line 3: | Line 3: | ||
1. Screw connectors together | 1. Screw connectors together | ||
| + | |||
| + | |||
[[Image:waterproofing1.jpg]] | [[Image:waterproofing1.jpg]] | ||
2. Tape over exposed areas | 2. Tape over exposed areas | ||
| + | |||
| + | |||
[[Image:waterproofing2.jpg]] | [[Image:waterproofing2.jpg]] | ||
3. Apply Butyl tape 5mm over each end of bottom layer | 3. Apply Butyl tape 5mm over each end of bottom layer | ||
| + | |||
| + | |||
[[Image:waterproofing3.jpg]] | [[Image:waterproofing3.jpg]] | ||
4. Tape 5mm over each end of Butyl tape | 4. Tape 5mm over each end of Butyl tape | ||
| + | |||
| + | |||
[[Image:waterproofing4.jpg]] | [[Image:waterproofing4.jpg]] | ||
Revision as of 15:13, 3 June 2009
This howto was compile by Scoop You can see the online version at http://www.scoopdistribution.co.za/wug/wug.html
1. Screw connectors together
2. Tape over exposed areas
3. Apply Butyl tape 5mm over each end of bottom layer
4. Tape 5mm over each end of Butyl tape
